59 ₽
Как это работает?
1
Выбираете товар
Добавьте интересующие вас товары в корзину
2
Оформляете заказ
Заполните все поля формы, чтобы получить предложение
3
Получаете предложения
В ближайшее время с вами свяжется менеджер для уточнения деталей
AIOHappyModel CrazyF411 AIO Flight Controller (FrSky / 20A / 2-4S)
CrazyF411 pro is a highly packed 2-4S AIO F4 flight controller with a built-in 20/25A per channel ESC and diversity FrSky SPI receiver. Built into a compact design, this AIO FC is perfect toothpick drones! FEATURES: Large soldering pads with 4 angled motor connectors for solder-free swap-outs Two, UARTs, with UART 1 inverted Compatible with 110x/120X/130X/140X motors Integrated with a F411 processor, Betaflight OSD, 5V 1.5A BEC SPECIFICATIONS: Flight Controller: MCU: STM32F411CEU6 (100MHZ, 512K FLASH) Sensor: MPU-6000(SPI connection) Board Size: 28.5 x 28.5mm Power Supply: 2-4S battery input (DC 8V-17V) Built-in 20A(each) Blheli_S 4in1 ESC Dshot600 ready Built-in Frsky D8/D16 SPI receiver (Built-in 2.4G Power Amplification) Built-in Betaflight OSD (SPI Control) Built-in Current meter Built-in 5V 1.5A BEC Built-in voltage detection Firmware target: MATEKF411RX Yaw Degrees should set to “-90 degree” to match the flight direction ESC: MCU upgraded to EFM8BB21 Power supply: 2-4S LiPo/LiPo HV (7v/17v) Current: 20A continuous peak 25A (5 seconds) Support BLHeliSuite programmable Factory firmware: F_H_40_REV16_7.HEX Default protocol: DSHOT600 Receiver: SPI BUS receiver Compatible With: FrSky D8/D16 Compatible with: Non EU transmitter both D8 mode and D16 mode Channels: 8CH/16CH Dual antenna Failsafe support No ground interference (Transmitter and receiver 1m from the ground): 400m HELPFUL LINKS: Manual Diff Documents INCLUDES: (1) HappyModel CrazyF411 25A AIO Flight Controller (with motor connectors pre-soldered)(2) IPEX U.Fl Linear Antennas(1) XT30 Pigtail(1) Hardware Set59RUB
CrazyF411 pro is a highly packed 2-4S AIO F4 flight controller with a built-in 20/25A per channel ESC and diversity FrSky SPI receiver. Built into a compact design, this AIO FC is perfect toothpick drones! FEATURES: Large soldering pads with 4 angled motor connectors for solder-free swap-outs Two, UARTs, with UART 1 inverted Compatible with 110x/120X/130X/140X motors Integrated with a F411 processor, Betaflight OSD, 5V 1.5A BEC SPECIFICATIONS: Flight Controller: MCU: STM32F411CEU6 (100MHZ, 512K FLASH) Sensor: MPU-6000(SPI connection) Board Size: 28.5 x 28.5mm Power Supply: 2-4S battery input (DC 8V-17V) Built-in 20A(each) Blheli_S 4in1 ESC Dshot600 ready Built-in Frsky D8/D16 SPI receiver (Built-in 2.4G Power Amplification) Built-in Betaflight OSD (SPI Control) Built-in Current meter Built-in 5V 1.5A BEC Built-in voltage detection Firmware target: MATEKF411RX Yaw Degrees should set to “-90 degree” to match the flight direction ESC: MCU upgraded to EFM8BB21 Power supply: 2-4S LiPo/LiPo HV (7v/17v) Current: 20A continuous peak 25A (5 seconds) Support BLHeliSuite programmable Factory firmware: F_H_40_REV16_7.HEX Default protocol: DSHOT600 Receiver: SPI BUS receiver Compatible With: FrSky D8/D16 Compatible with: Non EU transmitter both D8 mode and D16 mode Channels: 8CH/16CH Dual antenna Failsafe support No ground interference (Transmitter and receiver 1m from the ground): 400m HELPFUL LINKS: Manual Diff Documents INCLUDES: (1) HappyModel CrazyF411 25A AIO Flight Controller (with motor connectors pre-soldered)(2) IPEX U.Fl Linear Antennas(1) XT30 Pigtail(1) Hardware Set59RUB4.5575715